8e6 Technologies ProxyBlocker MSA-004-005 Manual do Utilizador Página 1

GUIDE ProxyBlocker®QUICK START Model: ProxyBlockerMSA-004-005 Release: 1.0.00 / Updated: 02.11.08

6 8e6 ProxyBlocker Quick Start GuideRack Mount the ServerRack Setup PrecautionsWarning:Before rack mounting the server, the physical environment shou

8e6 ProxyBlocker Quick Start Guide 7 Rack Mount InstructionsOptional: Install the Chassis RailsNOTE: If your chassis does not come with chassis

8 8e6 ProxyBlocker Quick Start Guide3. Locate the three holes on each side of the chassis and locate the three correspond-ing holes on each of the i

8e6 ProxyBlocker Quick Start Guide 9 Optional: Install the Traditional UP RacksAfter you have installed the inner rails on the chassis, you are ready

10 8e6 ProxyBlocker Quick Start Guide7. Slide the chassis into the rack as shown below.NOTE: The chassis may not slide into the rack smoothly or eas

8e6 ProxyBlocker Quick Start Guide 11 Optional: Install the Open RacksAfter you have installed the inner rails on the chassis, you are ready to insta

12 8e6 ProxyBlocker Quick Start Guide3. Attach the front (short) bracket to the front end of the rack, and secure it to the rack with two Type H scr

8e6 ProxyBlocker Quick Start Guide 13 6. Slide the inner rails which are attached to the chassis into the outer rails on the rack.

14 8e6 ProxyBlocker Quick Start GuideInstall the Chassis into the RackCAUTION: Before installing the chassis into the rack:• Make sure that the rack

8e6 ProxyBlocker Quick Start Guide 15 Check the Power SupplyThis server is equipped with a universal power supply that handles 100-240 V, 50/60 Hz. A

ii 8e6 ProxyBlocker Quick Start Guide8e6 ProxyBlocker Quick Start Guide© 2008 8e6 Technologies. All rights reserved. This document may not, in whole

16 8e6 ProxyBlocker Quick Start GuideGeneral Safety InformationServer Operation and Maintenance PrecautionsWarning:Observe the following safety preca

8e6 ProxyBlocker Quick Start Guide 17 AC Power Cord and Cable PrecautionsWarning:The AC power cord for the server must be plugged into a grounded, po

18 8e6 ProxyBlocker Quick Start GuideMotherboard Battery Precautions Caution:The battery on the motherboard should not be replaced without following

8e6 ProxyBlocker Quick Start Guide 19 Install the serverStep 1: Setup ProceduresThis step requires you to link the workstation to the ProxyBlocker. Y

20 8e6 ProxyBlocker Quick Start GuideStep 1A: Wizard Setup ProceduresLink the Workstation to the ProxyBlockerMonitor and Keyboard SetupA. Connect t

8e6 ProxyBlocker Quick Start Guide 21 HyperTerminal Setup ProceduresIf using a serial console, follow these procedures to create a HyperTerminal sess

22 8e6 ProxyBlocker Quick Start GuideC. At the Connect using eld, select the COM port assigned to the serial port on the laptop (probably “COM1”),

8e6 ProxyBlocker Quick Start Guide 23 F. In the HyperTerminal session window, go to File > Properties to open the Properties dialog box, displayi

24 8e6 ProxyBlocker Quick Start GuideLogin screenThe login screen displays after powering on the ProxyBlocker unit.NOTE: If the screensaver currently

8e6 ProxyBlocker Quick Start Guide 25 System Conguration: Administration menuA. At the Press the number of your selection prompt, press 2 to select

8e6 ProxyBlocker Quick Start Guide iii Contents8e6 ProxyBloCker IntroduCtIon ...1About th

26 8e6 ProxyBlocker Quick Start GuideSystem Status ScreenThe System Status screen contains the following information:Capturing Interface specied in

8e6 ProxyBlocker Quick Start Guide 27 Step 1B: Console Setup ProceduresPreliminary SetupCreate a “setup workstation” using a Windows-based laptop or

28 8e6 ProxyBlocker Quick Start GuideLink the Workstation to the ProxyBlockerThe procedures outlined in this sub-section require the use of the CAT-5

8e6 ProxyBlocker Quick Start Guide 29 If you wish to verify that the unit has been booted up, you can perform the following test on your workstatio

30 8e6 ProxyBlocker Quick Start Guide The Introductory Window displays minimized when the login dialog box of the Proxy-Blocker Administrator consol

8e6 ProxyBlocker Quick Start Guide 31 NetworkClick the System button at the top of the screen to go to the System section of the con-sole:In this sec

32 8e6 ProxyBlocker Quick Start GuideNetwork: Operation ModeFrom the navigation panel at the left of the screen, click Mode and choose Operation Mode

8e6 ProxyBlocker Quick Start Guide 33 Network: LAN SettingsFrom the navigation panel, click Network and choose LAN Settings from the pop-up menu: Mak

34 8e6 ProxyBlocker Quick Start GuideE. Enter the Secondary IP address of the second DNS name server. The ProxyBlocker will use this name server to

8e6 ProxyBlocker Quick Start Guide 35 NOTE: If you need to nd another NTP server to use, most university Web sites provide these servers for public

iv 8e6 ProxyBlocker Quick Start Guide

36 8e6 ProxyBlocker Quick Start GuideB. At the Location pull-down menu, select the time zone for the specied region. If necessary, select a langua

8e6 ProxyBlocker Quick Start Guide 37 Step 2: Test the ProxyBlocker Console ConnectionNow that the ProxyBlocker is physically installed on your netwo

38 8e6 ProxyBlocker Quick Start GuideStep 3: Test FilteringOnce you have accessed the ProxyBlocker Administrator console, you should test lter-ing.A

8e6 ProxyBlocker Quick Start Guide 39 You may wish to print the conrmation page for future reference in dealing with tech-nical issues.Perform a C

40 8e6 ProxyBlocker Quick Start GuideMonitor the Library Update ProcessTo verify that the library is being updated:A. From the navigation panel, cli

8e6 ProxyBlocker Quick Start Guide 41 ConClusIonCongratulations; you have completed the ProxyBlocker quick start procedures. Now that the ProxyBlocke

42 8e6 ProxyBlocker Quick Start Guideled IndICators and ButtonsMSA UnitsFront LED Indicators and Buttons for Hardware Status MonitoringLED indicators

8e6 ProxyBlocker Quick Start Guide 43 regulatory sPeCIfICatIons and dIsClaImersDeclaration of the Manufacturer or ImporterSafety ComplianceUSA: UL 60

44 8e6 ProxyBlocker Quick Start GuideEC Declaration of ConformityEuropean Community Directives Requirement (CE)Declaration of ConformityManufacturer’

8e6 ProxyBlocker Quick Start Guide 45 IndexAActivate and Register the ProxyBlocker 38BBoot Up 28Ccrossover cable 19, 28, 36EEMC 43, 44FFCC 43HHy

8e6 ProxyBlocker Quick Start Guide 1 8e6 ProxyBloCker IntroduCtIonThank you for choosing to evaluate the 8e6 Technologies ProxyBlocker. The Proxy-Blo

46 8e6 ProxyBlocker Quick Start GuideUUL 43Wwizard setup 19, 26

8e6 ProxyBlocker Quick Start Guide 47

8e6 Corporate Headquarters (USA): 828 West Taft Avenue Orange, CA 92865-4232 • Tel: 714.282.6111 or 888.786.7999 Fax: 714.282.6116 (Sales/Technical Su

2 8e6 ProxyBlocker Quick Start GuideAbout this DocumentThis document is divided into the following sections:Introduction - This section is comprised

8e6 ProxyBlocker Quick Start Guide 3 servICe InformatIonThe user should not attempt any maintenance or service on the unit beyond the proce-dures out

4 8e6 ProxyBlocker Quick Start GuidePrelImInary setuP ProCeduresUnpack the Unit from the CartonInspect the packaging container for evidence of mishan

8e6 ProxyBlocker Quick Start Guide 5 Select a Site for the ServerThe server operates reliably within normal ofce environmental limits. Select a site